Injection molding
Yes, but the addition ratio and usage conditions must be strictly controlled. Injection molding scrap (gates, runner scrap, and crushed defective parts) has physical properties basically the same as virgin material. After crushing, it can be mixed with virgin material in proportion—a common cost-reduction practice in the injection molding industry. However, every time scrap goes through high-temperature plasticization, its material properties degrade to some extent, so it cannot be reused indefinitely or blended at unlimited ratios.
1. Key Limits: Ratio and Number of Cycles
In industrial production, the recommended addition ratio for injection molding scrap is generally no more than 25%. Requirements are more specific in different scenarios:
·Products with high appearance requirements or complex structures: It is best not to add scrap, or to keep it within 25% at most.
·Simple, non-load-bearing internal parts: The ratio can be relaxed, but when adding more than 40%, samples usually need to be submitted for strength and function testing.
·Transparent parts and optical parts: Recycling is generally not recommended, or the ratio should be kept extremely low, because trace impurities and degradation products directly affect appearance.
In terms of the number of reuse cycles, different materials vary noticeably in tolerance. PP and PE are relatively tolerant of recycling, followed by ABS, while PA, PC, and POM are more sensitive to thermal history and more prone to performance decline with repeated use. The general principle is: scrap should not be recycled repeatedly; it should be replaced regularly to avoid cumulative material aging that affects product quality.
2. Risks to Watch For
The core risk of recycling injection molding scrap lies in the progressive degradation of material properties. Each high-temperature processing cycle causes molecular chain scission, manifested as increased melt index and decreased impact strength—products may become brittle. In addition, if the scrap picks up dust, oil, or other colors during storage or crushing, it will also affect finished product quality. Contaminated scrap should not be added to light-colored materials.
3. Better Practices
If conditions permit, reducing scrap generation at the source is more cost-effective than recycling after the fact. For example, using a hot runner system can fundamentally avoid the generation of runner scrap. For scrap that has already been generated, the precision injection molding field often uses in-line crushing and immediate recycling systems, blending scrap back into virgin material in proportion before its physical properties are severely damaged. This improves raw material utilization and reduces the risk of contamination during storage.





